A simple cost-effective alternative to clamps or bars. Simply cut off the amount you require and mix to form a putty type material.
The putty is then moulded around where it is needed, i.e. around the pin and bar interface or around the end of the pin if acting as a connecting bar.
Can also be used to cover the ends of sharp pins and bars.
Should always be on hand as a ‘Plan A’ or ‘Plan B’ when needed but it must be remembered that once set it cannot be modified.
The time it takes to set must be considered and its strength once it is set is low compared to steel or other materials of clamp or connecting bar and so it cannot be used where it will bear a lot of weight.


175mm Epoxy Resin Stick
£20.00

A simple cost-effective alternative to clamps or bars. Simply cut off the amount you require and mix.....

75mm Epoxy Resin Stick
£10.00

A simple cost-effective alternative to clamps or bars. Simply cut off the amount you require and mix.....