Used to create an accurate osteotomy.
1.6mm guide holes are drilled at the top and bottom of desired osteotomy site and a 1.6mm pin is placed through the saw guide into those guide holes to hold the saw guide in place. Alternatively a pin could be used through the guide holes and the pin could slot in behind an anatomical structure to hold it in place. The oscillating saw blade then fits through the slot and it guides the osteotomy.
If the desired osteotomy is less than the length of the saw guide simply use our saw guide stopper. This is a pin which inserts into a guide hole at the end of your osteotomy (2 and 3mm pins available). Attached to this pin a flat piece of steel with a ‘fin’ as it were which protrudes into the saw guide therefore stopping your saw blade progressing past that point.


Osteotomy Saw Guide
£88.00

Used to create an accurate osteotomy. 1.6mm guide holes are drilled at the top and bottom of desire.....

Osteotomy Saw Guide and 2/3mm Stopper Set
£187.00

Used to create an accurate osteotomy. 1.6mm guide holes are drilled at the top and bottom of desire.....

Osteotomy Saw Guide Stopper 2mm
£44.00

Used to create an accurate osteotomy. 1.6mm guide holes are drilled at the top and bottom of desire.....

Osteotomy Saw Guide Stopper 3mm
£44.00

Used to create an accurate osteotomy. 1.6mm guide holes are drilled at the top and bottom of desire.....